Standard
tip angle is 90[degrees] but 60[degrees] is also available.
Caption: In Alphacam 2017 R1, new depth control settings for the
tip angle of the tool and the cone angle of the hole let machinists drill the actual holes identified from automated feature extraction.
Minimum temperature of 31C was achieved at speed of 186 rpm, feed of 0.196 mm/rev, drill diameter of 3.85mm, and drill
tip angle of 110.
There are two schools of thought when it comes to
tip angle and whether to pull or push the caulk.
Tip Angle:
Tip angle can range from 40[degrees] to 120[degrees] allowing access to both straight occlusal surfaces and the distolingual grooves of upper molars.
Visual field of camera is a right circular cone with the
tip angle of 60 [degrees].
Pins come in flat position, wrench flats,
tip angle, relief at thread end, and shoulder top radius designs.
* Pins that are offered in flat position, wrench flats,
tip angle, relief at thread end and shoulder top radius designs.
For conventional woodworking chisels and plane irons, this means a
tip angle of 25 to 30 degrees.
Maximum
tip angle is 70[degrees], with a 10.4 second raise and seven second lowering time for quick cycles to increase productivity on the job, JCB said.
Whereas a fully destructive [phi]/2 rad
tip angle was used for the calibration FID signal, a
tip angle of 0.070 rad was used for the compressed gas.