tin oxide


Also found in: Dictionary, Encyclopedia.
Related to tin oxide: Tin dioxide

stan·nic ox·ide

(stan'ik oks'īd),
Agent used in industrial manufacture; causes pneumoconiosis.
Synonym(s): tin oxide
Farlex Partner Medical Dictionary © Farlex 2012

tin oxide

(1) Stannous oxide; tin monoxide. 
(2) Stannic oxide; tin dioxide.
Segen's Medical Dictionary. © 2012 Farlex, Inc. All rights reserved.
References in periodicals archive ?
[5] TANAKA Kikinzoku Kogyo's metal mesh wiring technology: Metal mesh is a wiring format in a grid pattern that uses silver or copper for sensor wires rather than indium tin oxide (ITO).
Wee, "Investigation of annealing effects on indium tin oxide thin films by electron energy loss spectroscopy," Thin Solid Films, vol.
Serventi et al., "Pulsed laser deposition of nanostructured tin oxide films for gas sensing applications," Sensors and Actuators B: Chemical, vol.
Benhaoua, "Structural, optical and electrical properties studies of ultrasonically deposited tin oxide (Sn[O.sub.2]) thin films with different substrate temperatures," Superlattices and Microstructures, vol.
Tin(IV) chloride (Sn[Cl.sub.4] x x[H.sub.2]O) used as the precursor for the synthesis of tin oxide NPs and ammonia solution (N[H.sub.4]OH) were purchased from Sigma-Aldrich.
Figure.1 shows a typical X Ray diffraction patterns for the as-deposited indium tin oxide thin films prepared at 200[degrees]C, 225[degrees]C, 250[degrees]C and 275[degrees]C.
Figure 13 shows that the drop in MEA performance of a tin oxide support was much smaller than that of a conventional carbon support at a high potential of 1.3 V (80[degrees]C/90% RH./4 hours).
Mohd, "Structural, Optical and Electrical Properties of Fluorine Doped Tin Oxide Thin Films Deposited Using Inkjet Printing Technique," Sains Malaysiana, vol.
As a result, coating with very good homogeneity of tin, tin oxide, and indium oxide was deposited.
Single layers of indium tin oxide (ITO), aluminum-doped zinc oxide (AZO), and Ag, bilayers of ITO/Ag and AZO/Ag, and sandwiched layers of ITO/Ag/ITO (IAI) and AZO/Ag/AZO (ZAZ) were fabricated, respectively, onto ordinary soda lime glass substrates (40 mm x 40 mm x 2 mm) using three-target sputtering.
The main drawback of tin oxide however is its low selectivity towards reducing gases and thus cross sensitivity between these gases is one of the major problems [8].
The precipitate of hydrated tin oxide was obtained by the reaction between ammonium hydroxide and tin chloride (IV) solutions.