Therefore, low values were recorded in Cc-[SP.sub.1] when compared to those data found in Cc-[SP.sub.2] and Cc-[SP.sub.3] (Table 1 and Figure 1), revealing thus the occurrence of distinct SPs and that the employment of different NaCl molarities
was important for C.
According to , the authors concluded that, under varying initial gold chloride concentration, the size evolution of the generated GNPs exhibited two different patterns: one for HAu[Cl.sub.4] molarities
less than [10.sup.-3] mol and the other one for the HAu[Cl.sub.4] molarities
greater than or equal to [10.sup.-3] mol.
In order to establish the optimum pH value for each ion pair formed, various acids, for example, acetic, hydrochloric, and sulphuric acids of different molarities
, were studied.
The copy numbers for each genotype were calculated from the molarities
provided by the Agilent software.
where [(g.sup.GT.sub.K] and [N.sup.GT.sub.Ca] are the respective adsorbed activity coefficients of the K and Ca ions; [N.sub.K] and [N.sub.Ca] are the respective equivalent fractions of [K.sup.+] and [Ca.sup.2+] on the exchanger; [[gamma].sub.K] and [[gamma].sub.Ca] are the activity coefficients of [K.sup.+] and [Ca.sup.2+] in the equilibrium solution; and [M.sub.K] and [M.sub.Ca] are the [K.sup.+] and [Ca.sup.2+] molarities
in the equilibrium solution.
On the contraction of smooth muscle in guinea-pig ileum, and rat stomach and colon: The muscle contraction induced by different molarities
of acetycholine (Ach) was compared to that elicited by different dilution's of the secretion.
A decrease in voltage is observed at molarities
of acid solution greater than this.
Figure 1 shows the current density per unit mass, J/[m.sub.gel], versus applied voltage, U, for junctions formed with both two neat gels (undoped gels) and two oppositely doped gels having different monomer molarities
. When the junction was constructed by using neat gels, no rectification is observed on the current density (Fig.
All samples were cleaned and polished and then washed with HCl and NaOH with four molarities
. Finally the samples immersing in distilled water and drying carefully.
of sodium hydroxide (NaOH) solution of 12 M and 14 M were prepared for each mix proportion.
The aqueous polymerization of OPDA (0.1 mol) was carried out in 25 mL of HCl solution (0.2 mol) in the presence of 25 mL potassium dichromate as oxidant of different molarities
at 5[degrees]C for different time intervals.
for [La.sub.2][O.sub.3] and BaN[O.sub.3] were fixed, while molarities
for Mn(N[O.sub.3]) and Al(N[O.sub.3]) were calculated by following the stoichiometric.