metal interface

met·al in·ter·face

in dentistry, a boundary between metal and nonsolvent solder, or between metal and surface oxide.
Farlex Partner Medical Dictionary © Farlex 2012

met·al in·ter·face

(metăl intĕr-fās)
In dentistry, boundary between metal and nonsolvent solder, or between metal and surface oxide.
Medical Dictionary for the Dental Professions © Farlex 2012
References in periodicals archive ?
The testing results validate previous research that more energy from the aluminum casting is being used by the higher resin percentage at the mold metal interface before this energy is being transferred further into the mold.
Caption: Figure 5: (a) SEM micrographs showing cracking behavior in the deposit/base metal interface for the sample repaired and (b) SEM image suggesting the delineation of the crack paths by resolidified products, typical of liquation cracking.
A second time constant was apparent for both the DTM and 2C1B coating, which may be attributed to the corrosion reaction occurring at the coating metal interface. Ret represents the resistance to the corrosion reaction at the coating/metal interface, which was higher for 2C1B coating as compared to DTM coating, which indicated better corrosion protection at the edge for the 2C1B coating as compared to DTM coating.
Asymptotic average concentration at metal interface and throughout
The kinetics of resin metal interface at optimum pH, was calculated by the variation of sorption with time from kinetic equations i.e.
For this reason we needed to replace the standard brushed metal interface of the player with our own customized GUI (Graphical user interface) or skin.
The chip forming process implies that a fresh metal interface is continually produced and forced, at very high pressure and temperature, along the tool material.
This 100-fold accelerated test will require the use of a 100-fold higher galvanic current which would provide more insight into the failure mechanism at the cladding and metal interface and in regions below a scratch in the insulation corresponding to the aged condition.
When clay in the sand is heated at the mold metal interface, it loses moisture and may go through a phase change.
This would indicate that any A50P at the rubber metal interface has remained on the rotor, or not been deposited on the window.