autopolymer resin

(redirected from autopolymerizing resin)

au·to·pol·y·mer res·in

, autopolymerizing resin
any resin that can be polymerized by chemical catalysis rather than by the application of heat or light; used in dentistry for dental restoration, denture repair, and impression trays.

autopolymer resin

au·to·pol·y·mer res·in

, autopolymerizing resin (aw'to-pol'i-mĕr rez'in, aw'tō-pol'i-mĕr-īz-ing)
Any resin that can be polymerized by chemical catalysis rather than by the application of heat; in dentistry used in making dental restorations, denture repairs, and impression trays.
Synonym(s): cold cure resin, cold-curing resin.

au·to·pol·y·mer res·in

, autopolymerizing resin (aw'to-pol'i-mĕr rez'in, aw'tō-pol'i-mĕr-īz-ing)
Any resin that can be polymerized by chemical catalysis rather than by application of heat or light; used in dentistry for dental restoration, denture repair, and impression trays.
Synonym(s): activated resin, cold cure resin, self-curing resin.
References in periodicals archive ?
The putty was later removed from the distal end of the denture and the opening was sealed with autopolymerizing resin.
For the toothbrushing tests, the samples were embedded in PVC rings using autopolymerizing resin and mounted onto the toothbrushing test apparatus.
Place autopolymerizing resin into the matrix and seat onto the prepared teeth.
Disadvantage of magnets are their detachability from the resin denture bases, so care was taken to overcome that by air abrasion of magnet with alumina and application of primer to increase the bonding with autopolymerizing resin.
Autopolymerizing resin was placed in a dough stage on the flat incisal table and the resin was molded by moving the incisal pin through protrusive and lateral movements.
Monomer appli cation to denture teeth also compromised bonding to an autopolymerizing resin.
The implants were restored with autopolymerizing resin splinted temporary crowns.
Custom trays were fabricated in autopolymerizing resin and final impression taken in zinc oxide eugenol impression paste after border moulding.
5 Another technique involves the addition of autopolymerizing resin onto the posterior palatal seal area directly in the mouth.
Remove the putty and fabricate 2 covers using clear autopolymerizing resin.
Autopolymerizing resin base plates were fabricated.
Setting characteristics of five autopolymerizing resins measured by an oscillating rheometer.