The development of adhesive strength
on the interface in polymers is often referred to as healing.
The adhesive strength
of hardened mortar was not affected by the replacement ratio.
In general high adhesive strength
was obtained for the coatings GP9 to GP12.
Jenni, A., et al., Influence of polymers on microstructure and adhesive strength
of cementitious tile adhesive mortars.
The trend towards miniaturisation of components has created a need for determining the mechanical load capacity of thin films and coatings, including adhesive strength
(4,46) The pull-off adhesion test was performed to determine the adhesive strength
of the coatings on a metal substrate; the results are reported in Table 4.
With their education level rising, consumers were more aware and placed higher importance on certain factors such as adhesive strength
and quality, healing quality, and absorbency.
These coating agents can further enhance adhesive strength
of the ink, while maintaining its electro-conductivity.
I recently came upon an excellent paper on measuring wet adhesive strength
via a scratch test [H.
In this research, the values of adhesive strength
were calculated 24.6 and 38.12 MPa for conventional yttria stabilized zirconia (YSZ) thermal barrier coatings and plasma-sprayed nanostructure, respectively.
Eick, "Application of solubility parameter theory to dentinbonding systems and adhesive strength
correlations," Journal of Biomedical Materials Research, vol.