adherend


Also found in: Dictionary, Encyclopedia.

adherend

A material or substance which adheres to another, often understood to mean as a result of an adhesive applied to the adherend.
Mentioned in ?
References in periodicals archive ?
For aluminum bonded joints a glycidoxypropyltrimethoxysilane--epoxy silane (Silqeust A-187 Silane, Momentive Company, USA), was used as a primer to chemically modify the aluminum adherends.
Toughening of Epoxy Systems by Brominated Epoxy
Interface corner failure analysis of joint strength: effect of adherend stiffness, International Journal of Fracture, 88(4):305-314.
Experimental and Numerical Investigation of Adhesively Bonded Curved Lap Joints under Three-Point Bending
Antunes, "Effect of adherend's rigidity on the shear strength of single lap adhesive joints," International Journal of Adhesion and Adhesives, vol.
Simulation Analysis and Experimental Study on Strength Optimization of a Plug-In Oil Hose Joint
Because physical and elastomechanical properties of the adherend are changed by wood modification, it is hypothesized that surface processing causes differentiating surface textures.
Distinctive Impact of Processing Techniques on Bonding Surfaces of Acetylated and Heat-Treated Beech Wood and Its Relation to Bonding Strength
Adherend Young's modulus (MPa) 69450 Adhesive Young's modulus (MPa) 330 Adherend Poisson ratio 0.33 Adhesive Poisson ratio 0.35 Adherend thickness, t (mm) 2 Adhesive thickness, d (mm) 0.2 Overlap length, L (mm) 20 Free adherend length, l (mm) 90 Applied load, P (MPa) 20 Reinforcement thickness, h (mm) 2 Reinforcement length, R (mm) 30, 40, 50, 60, 70, 80 [DELTA]R = R - L, [DELTA]R (mm) 10, 20, 30, 40, 50, 60 Table 2: Stress intensity factor in single-lap joints.
Influence of Reinforcement Length on Singularity of Single-Lap Joints
Adherend material is aluminum alloy 7075-T6 plate with 2mm thickness and epoxy based Araldite 2011 is used for the bonding of the substrates.
Effect of Reduced Graphene Oxide Reinforcement on Creep Behavior of Adhesively Bonded Joints
A Splitting of contracts is not provided, since the production and foiling be carried out by a supplier and the start of production usually is not known at what location are the adherend vehicles.
Vehicle graphics framework agreement
Wood as an adherend. In: Treatise on Adhesion and Adhesives.
Fundamental Bonding Properties of Douglas-Fir and Southern Yellow Pine Wood
The numerical simulation of bonded assembly in three-dimensional is known delicate for reasons related to the mesh at the interface between adhesive and adherend plats, especially when dealing an elastic-plastic material of adhesive and the substrates.
Three-dimensional finite element analysis of fracture behaviour of adhesively bonded single lap-joints
However, the adhesion between the adhesive and the backing is still important in that a low level of adhesion at this locale would result in transfer of the adhesive from the backing to the adherend.
Adhesion at polymer interfaces and pressure sensitive adhesive tapes
The compensating plate was prepared with the same thickness corresponding to specific adherend.
Strength and Failure Mechanism of Composite-Steel Adhesive Bond Single Lap Joints
Therefore, the information above illustrates the different patterns between PRF- and PU- bonded wood samples in terms of wood failure: PU adhesive may result in more cohesion or adhesive-adherend failure, whereas PRF adhesive results in more adherend failure or wood failure.
Evaluation of the performance of composite wood decking bonded with phenol resorcinol formaldehyde and polyurethane adhesives after accelerated aging tests

Medical browser ?
Full browser ?