TABLE 1: SHEAR BOND STRENGTHS
(MPA) IN GROUP A AND GROUP B
The hypothesis tested were that (1) CHX treatment would result in higher bond strengths
compared to groups without CHX treatment; and (2) increased storage times would present higher degradations in microtensile bond strengths
5% antibiotics produced bond strengths
similar to those of the control GICs and do not change the properties of GICs, but a significant reduction in bond strength
was observed for GICs containing 3% and 4.
Though the literature indicates good but inconsistent results with the use of flowable composite liners and RMGIC liners under the composite restorations, very few studies have presented the comparative analysis of the bond strengths
of flowable composite liners with the RMGIC liners.
A similar study that simulated aging of composite resin repairs with thermocycling reported decreased bond strengths
among aged repaired composites that received different surface treatments.
15 However, it is difficult to compare equitably the bond strengths
from different testing specimens by using the push-out test.
OmniLam F (flexo) and OmniLam G (gravure) are non-nitrocellulose ink systems that deliver high bond strengths
on a wide range of film structures.
shEar Bond strEngths
BEtWEEn diffErEnt zirconia corEs and vEnEEring cEraMics and thEir suscEptiBility to thErMocycling.
Our work with soy flour has shown that dry and wet adhesive bond strengths
for samples made and tested using this ABES method were remarkably insensitive to the type of soy flour used (Frihart and Satori 2012) or to the addition of chaotropic agents, salts, surfactants, and co-solvents to the soy flour (Frihart and Lorenz 2013).
In vitro evaluation of push-out bond strengths
of various luting agents to colored posts, J Prosthet Dent, 95: 302-310.
The conventional grouts shrank more, had only modestly higher compressive and bond strengths
, cracked earlier, and cost substantially more.
When the bond strengths
of the exposed specimens for three groups, which varied with different surface conditions, are compared with each other, it is shown that the average value of the bond strength
was higher for the exposed specimens modified by the epoxy-functional silane.