HART

(redirected from 4-20 mA)
Also found in: Dictionary, Thesaurus, Legal, Encyclopedia.

HART

Cardiology A clilnical trial–Heparin-Aspirin Reperfusion Trial that compared adjuncts to tPA thrombolysis in Pts with acute MI. See Acute myocardial infarction, Heparin, tPA.

Patient discussion about HART

Q. please: send me information about sexual power medicine. i have hart operation 6 month ago. thanks atte caiman

A. most problems there are psychological more then physiological. i would try there. there's also a row of alternative treatments you can try, like biofeedback and acupuncture. try them and let me know ;)

More discussions about HART
References in periodicals archive ?
Unamplified output signal of 3 mv/v and optional internal electronic amplified signal of 0-5 v d-c or 4-20 mA. It has a 1.7 in.
High-level outputs (4-20 mA, 0-5 volts d-c, 0-10 volts d-c) are available on all melt-pressure transducers.
Over 60 analog and digital temperature meters include thermometers with stainless-steel and upright stems; panel-mount meters and transmitters with type J, K, T, and E thermocouple probes; strip-chart and circular temperature recorders; infrared meters for noncontact measurement (portable and remote models with 4-20 mA output); and multichannel, 4-20 mA or 0-5 VDC temperature monitors with alarm systems.
* The 4-20 mA output makes the SMI-L suitable for geotechnical applications where long cable runs are required since there is no signal loss due to.
The commercial Type D1005PS is a 2 1/2" gauge with [+ or -] 0.5% FS accuracy, while the industrial Types 2074, 2174 and 2274 3" and 4 1/2" gauges are rated at [+ or -] 0.25% FS and are available with 4-20 mA output and on-board SPDT switches.
The drive has an H-O-A switch with a 10-turn potentiometer for manual control and will accept a 4-20 ma process signal through a standard 1/2 UNF connector.
The SOLID line is a range of transducers, 4-20 mA transmitters and composite connectors designed and built to withstand tough environments under the most demanding conditions.
This water-resistant meter has three modes: Pulse/Time, Peak Detect and 4-20 mA. The Pulse/Time and Peak Detect functions are key measures of the transmitter's operating parameters.
Millivolt, voltage, and 4-20 mA outputs available on standard products.
The module can be used as a 4-20 mA component or a Modbus RTU node.
The two-wire design utilizes 24 Vdc power with 4-20 mA output and is used as a direct interface with existing control and data acquisition systems.
A DIP switch on each unit allows the following selection of control inputs: 1-135 ohms, 4-20 mA, 0-5 V.