screw clamp

(redirected from clamping screw)
Also found in: Encyclopedia.

screw clamp

Etymology: OFr, escroe, screw; AS, clam, fastener
a device, usually made of plastic, equipped with a screw that can be manipulated to close and open the primary IV tubing for regulating the flow of IV solution. Turning the screw clockwise closes the tubing; turning it counterclockwise opens it. Different positions of the screw between the open and the closed positions allow the IV fluid to flow at different rates. Compare roller clamp, slide clamp.
References in periodicals archive ?
Further information on Elesa retained clamping screws may be found at: www.
If the barrel is badly fouled or the chamber shows a need of some polishing, loosen the two rear clamping screws and completely remove the front one (306).
As most of the cutting force is transferred to the pocket instead of to the clamping screw, high clamping force and precision of the cutting edge location are maintained even during high feed machining.
Tenders are invited for Clamping Screw To Widia Ordering Code No.
The RCCW inserts have a cylinder on the bottom that mounts in a mating hole in the pocket, providing very firm clamping with the cylinder absorbing most of the stresses normally exerted on the clamping screw.
The RCCW inserts have a cylinder on the bottom that mounts in a mating hole in the pocket, a design that provides very firm clamping with the cylinder absorbing most of the stresses normally exerted on the clamping screw.
Tightening the pull rod with the clamping screw exerts holding force on the crown/body that enables it to withstand the same high feeds as a brazed drill.
This design provides very firm clamping with the cylinder absorbing most of the stresses normally exerted on the clamping screw.
Tenders are invited for 4 Jaw Hand Operated Combination Chuck,Size-630Mm Dia For 12Mhec Boring M/C(Model No-Bdh 140N/12M) With 1 Set Of Hard Jaw(Reversible),1 No Jaw Screw Wrench,Chuck Key,Tommy Bar And 1Set Chuck Clamping Screw To Suit Spindle Having Nose A-15 Is:2582 As Per Scope Of Supply.
To achieve this, the ABS clamping screw is loosened and the eccentric sleeve is adjusted to the correct dimension against the scale.
Limited tenders are invited for supply of CLAMPING SCREW WITH HOLDER (COLLIMATOR STAND),BUCKLE (COLLIMATOR STAND),HOOK (COLLIMATOR STAND),END CLIP (COLLIMATOR STAND)
Insert Clamping Screw Plus 01 Torx Wrench Note:- One Insert Shall Be Able To Manufacture The 08 Nos.